|
Blower Resistor and Connector Replacement
Instructions
Needed Tools:
- 1/4 inch ratchet wrench w/ a 1 inch
extension, 7mm & 5.5mm sockets
- Wire cutting pliers - Wire Stripper - Wire Crimping Tool - Heat
Gun
- Utility Knife - Electrical Tape
Step 1 - Remove the
Blower Circuit fuse - in the under hood fuse center on full size
trucks (40 Green) - Disconnect the battery if you cannot find the
fuse to avoid any doubt.
Step 2 - Remove 3 - 7mm head screws holding
the IP Hush Panel to the lower Dash - (if you are careful, there is
no need to remove this panel completely).
Step 3 - Remove the Blower Resistor - Disconnect the
blower circuit from the Blower Motor (1) - Disconnect the 7 wire
connector from the blower resistor (2) and remove two 5.5mm screws
holding the blower resistor to the heater case (3)
|
